|
They fit and stick but they were dirty and not as clear as they should be.
It moves around the screen. It is sticky on both sides so it obsorvs finger prints.It adds glory on the screen.
I tried to smooth them out but ended up pulling up the screen protector again, but the bubbles just kept getting worse. When I finally got it to lay acceptably, I smoothed it on, and smoothed out a few bubbles.
Although they have a pull tab on each side to easily seperate the cover from the backing, it is difficult to pull them apart. The paper pull tab easily tears, and will not come off the protective film easily.
In the package you get two protective covers and a cloth to clean the screen. It did not go on the screen smoothly and I had to pull it off and try a few times.
I had to use paint thinner to remove the sticky tab part, which got on the back of the film and ruined it. So I tried the second one, took off the tab first and cleaned the face with a much better result.
The next morning when I went to use my GPS, some bubbles had appeared. I'm waiting to find another product to try before I pull this one off.the bubbles don't hinder the responsiveness of the touch screen.they just look funny.
They get the job done and the pre cut sizes fit the screen pretty well.
Unless you are extremely careful and wear protective gloves, pass on this item. Removing the protective front and back covering is not difficult, but one touch of the protective plastic on the adhesive side leaves unremoveable smudges, and placing the protective plastic on the GPS screen leaves bubbles under the plastic that are difficult if not impossible to remove. This is going back for a refund.
|
